Editorial desk
Anycubic Guide Editorial
Anycubic Guide Editorial is the publishing identity for Anycubic Guide. It is a desk, not a person: no named author, no biography, no professional certifications.
Articles published under this byline are researched from primary sources — vendor and project documentation, published standards and specifications, research papers, and measurements published by whoever took them — drafted with AI assistance, and edited against those cited sources before publication. Nothing here is based on first-hand testing in a private lab, and any figure that appears is attributed to the source it came from.
Corrections go to [email protected]. More detail is on the about page and the editorial disclosure.
Posts (8)
- 3D Printing
Anycubic Resin Exposure Time Settings Explained
What Anycubic's exposure, bottom exposure, bottom layer, transition and off time settings do, the wiki's per-printer values, and how to check with R_E_R_F.
- 3D Printing
Anycubic Kobra 2 Not Extruding: Diagnosis and Fixes
A hand-push test separates extruder faults from hotend clogs, followed by checks for tension, heat creep, nozzle blockage, and PTFE liner damage.
- 3D Printing
Anycubic Kobra vs Photon: Which 3D Printer to Buy
Anycubic Kobra vs Photon models are compared by build volume, print detail, speed, running costs, ventilation needs, and slicer support.
- 3D Printing
Anycubic Photon Mono Resin Sticking to FEP: Causes and Fixes
A symptom-based guide covers leveling, exposure, resin temperature, peel force, and FEP film condition, with Photon Mono settings and verification steps.
- 3D Printing
Anycubic Bed Leveling: Paper Method and Z Offset Steps
Level an Anycubic Kobra or Photon with paper, then set Kobra Z offset from a first-layer test. Diagnose tilt, mesh, and adhesion problems.
- 3D Printing
Resin Types Compared: Which Anycubic Resin to Print With
Standard, high-speed, ABS-like, tough, plant-based, and water-washable resins are compared by exposure, durability, cleanup, and best uses.
- 3D Printing
Photon File Validator Is Archived: Use UVtools Instead
Photon File Validator is archived and supports older .photon files. Use UVtools to check current Anycubic Mono files for islands, resin traps and settings.
- 3D Printing
Resin MSLA or High Speed FDM: Which Process to Choose
How masked stereolithography and fused deposition differ in accuracy, materials, and workflow, and which decisions actually determine print quality.