All articles
Sourced setup guides for Anycubic printers: bed leveling and Z offset, choosing between resin MSLA and high-speed FDM, resin selection, and validating sliced files before a print.
-
How to Replace an FEP Film on an Anycubic Photon
Swap a worn FEP or ACF film on an Anycubic Photon vat: screw order, tension by drum sound, trimming, the IPA leak test and resetting the counter.
-
Anycubic Resin Exposure Time Settings Explained
What Anycubic's exposure, bottom exposure, bottom layer, transition and off time settings do, the wiki's per-printer values, and how to check with R_E_R_F.
-
Anycubic Kobra 2 Not Extruding: Diagnosis and Fixes
A hand-push test separates extruder faults from hotend clogs, followed by checks for tension, heat creep, nozzle blockage, and PTFE liner damage.
-
Anycubic Kobra vs Photon: Which 3D Printer to Buy
Anycubic Kobra vs Photon models are compared by build volume, print detail, speed, running costs, ventilation needs, and slicer support.
-
Anycubic Photon Mono Resin Sticking to FEP: Causes and Fixes
A symptom-based guide covers leveling, exposure, resin temperature, peel force, and FEP film condition, with Photon Mono settings and verification steps.
-
Anycubic Bed Leveling: Paper Method and Z Offset Steps
Level an Anycubic Kobra or Photon with paper, then set Kobra Z offset from a first-layer test. Diagnose tilt, mesh, and adhesion problems.
-
Resin Types Compared: Which Anycubic Resin to Print With
Standard, high-speed, ABS-like, tough, plant-based, and water-washable resins are compared by exposure, durability, cleanup, and best uses.
-
Photon File Validator Is Archived: Use UVtools Instead
Photon File Validator is archived and supports older .photon files. Use UVtools to check current Anycubic Mono files for islands, resin traps and settings.